THROTTLE CONTROLLER

Install / Calibration

Instructions on how to install:

  • Unplug the wire from the gas pedal at the connector.

  • Connect our Throttle Controller as shown.

  • Mount the main box somewhere under the dash using the double sided tape.

  • The wired remote can be disconnected to make it easier to be placed anywhere you like.

Throttle Controller Installation and Setup Instructions

Step-by-Step Installation

  1. Safety First

    • Make sure your engine is off, and if you have a manual transmission, set it to Neutral or Parking.

  2. Create Space

    • Push your driver’s seat all the way back to give you enough room to access under the dashboard.

  3. Disconnect the Existing Harness

    • Unplug the harness connected to your gas pedal.

    • First, push up the securing safety pin.

    • Then, pull the harness upward by holding the plastic connector, not the wires.

  4. Connect the Throttle Controller Harness

    • Now, plug the harness that comes with the controller into the gas pedal harness.

    • Male to female, and female to the gas pedal harness.

    • Make sure it’s fully plugged in until you hear a click sound.

  5. Optional Wires

    • The optional yellow and blue wires on the main unit are for Brakes/Launch Control options and will not be used during this installation.


Controller Setup Instructions

  1. Power On the Vehicle (Without Starting the Engine)

    • Turn your key to ACC or RUN position (without starting the engine).

    • For some cars, simply push and hold the Start button for a few seconds without touching the brake pedal.

  2. Initial Calibration

    • Once you see all the dashboard lights, press and hold the knob on your controller.

    • You should see a countdown:
      3 – 2 – 1 – 0

      • Once you see 0, release the knob.

  3. Set Low Voltage (Rest Position)

    • When the display shows L (Low Voltage), this represents the voltage value of your gas pedal at rest.

    • Do not press the gas pedal yet.

    • Press and release the knob once. The display will show SET, then H (High Voltage).

  4. Set High Voltage (Max Pedal Input)

    • When the display shows H (Voltage at rest), press the gas pedal to the floor and hold it there.

    • The high voltage value will display.

    • Press and release the knob once again.

    • Keep your foot on the gas pedal until the display shows 100.

    • You can now release the gas pedal.

  5. Finish Calibration

    • Turn off the ACC, and remove the key.

    • Calibration is complete, and your controller is now ready to use.


How to Use Your Throttle Controller

  • Sport Mode (SP):
    Press the knob once to toggle between Sport (SP) mode and Economy (EC) mode.

    • SP0: Stock settings

    • SP9: Highest throttle response

  • Economy Mode (EC):
    The Economy mode decreases the throttle response to help save fuel.

    • EC7: Most economical setting.


If you need any assistance or have questions, feel free to reach out to us:

Email: sales@vitesse-motorsports.com
Phone: (201) 708-7017